How much does it cost to repair a rear quarter panel?
Fixing a quarter panel will likely cost around $2,000, unfortunately. Body panel repairs, including quarter panel repairs, are usually expensive.
Can you repair a quarter panel?
Olson said any holes drilled in a used quarter panel might be 10 mm, perhaps 10.5 after deburring. As the OEM wants only 8 mm plug welds, it’s officially impossible to deliver the repair with a used quarter panel, according to Olson.
How hard is it to replace a rear quarter panel?
Like all things in life, however, it’s not quite so easy. On the surface, it’s a simple job: cut the old quarter-panel off and weld a new one on. Like all things in life, however, it’s not quite so easy. Because you’re welding the new panel on, undoing a poorly done install can be a major pain in the butt.
Is it better to repair or replace a quarter panel?
The reason for this is the quarter panel is much more expensive and labor-intensive to remove and replace. Replacing a welded-on quarter panel disturbs more of the original construction, such as seams, welds and corrosion protection, so more repair time can be allocated before the replacement threshold is met.
How long does it take to replace a rear quarter panel?
We Show You How To Replace A Rear Quarter-Panel With New Parts From Goodmark Industries.
|Replace left 1/4 panel
|Replace rear panel
Can a rear body panel be repaired?
The process of fixing a rear quarter panel can vary a little bit from body shop to body shop and vary based on the degree of damage that your vehicle sustained; however, the process generally goes as it is outlined above.
Is it better to repair or replace a quarter-panel?
How much does it cost to have a quarter-panel replace?
Like most body panel repairs, labor for replacing the quarter panel costs a pretty penny, with prices ranging from $1000 to $2000 depending on your location.
How do you Undent a quarter-panel?
Bring a pot of water to a boil and take it out to your vehicle. Slowly pour the hot water over the dent so it heats up the panel and makes it more malleable. After that, spray the area with compressed air to cool it down quickly. If you’re lucky, the dent will pop right out.