How do you clear a Trane thermostat error?

How do you clear a Trane thermostat error?

How to reset trane thermostat after power outage

  1. Turn the thermostat to the “Off” position. Wait a few minutes, then turn the thermostat either to “Heat” or “Cool.”
  2. Set the thermostat to the desired temperature.
  3. Go to the circuit breaker box if you do not feel or hear airflow.
  4. Turn the thermostat off and then on again.

How do I reset my Trane Comfortlink 2 thermostat?

Locate the switch for your thermostat in the breaker box. Flip the switch to the OFF position for 20-30 seconds. Return the switch to the ON position. The reboot process will take several minutes to complete.

Why is my Trane thermostat not working?

To unlock a Trane thermostat, press the plus (“+”) and minus (“-”) keys at the same time for three to four seconds, then try adjusting the temperature again. If this doesn’t work, try resetting your thermostat with the reset button, changing the batteries, or cleaning off any dust and dirt inside.

What is error code 126 on Trane thermostat?

Trane thermostat error code 126 Meaning: There might be a low-temperature lockout (the thermostat may have broken the electrical circuit due to ambient outdoor temperature dropping too low). Suggested fix: Try to reset the system.

Is there a reset button on a Trane air conditioner?

The button will usually be located in the rollout switch and connected by two wires on the opposite sides. The button is about the size of a coin. It may also be red. To initiate the reset, you’ll need to press the switch once.

Where is the Trane reset button?

Turn off the power and open up the control panel to access the reset buttons on these models. Next, lift the cover to the blower compartment, and you should see the reset button sitting next to the blower motor and blower wheel.

Where is the heat pump reset button?

Rheem and Ruud usually place their reset button near the bottom of the outdoor unit; the units with a reset button, in general, have it on the outside of the heat pump. Units that don’t have a button can be reset with the power switch and the circuit breakers.