How do I reset my Timeguard?
To clear programmes from memory and reset the time controller press and hold down both buttons until the display goes blank. Release buttons and display will fill with its complete range of characters and then clear to show clock and hour digit flashing.
How do you program a Timeguard?
Press and hold the Time button for 3 seconds, the word Hold will show on the screen. After 3 seconds release the Time button and the screen will show the year; Press the Time button repeatedly until the minutes are shown. Use Adv/Ovr or Boost to change the minutes to the correct value.
How do you set a Potterton timer?
Press and hold down the STEP & + button, then after 5 seconds, release the 2 buttons. The built-in times are now reinstated. Move slider to SET. Adjust ON1 time, using – & + buttons 1.4 Press STEP button.
How do you set a Timeguard thermostat?
To set/alter the time and date at any time, press and hold the Select button for 3 seconds. The display light will illuminate. The hour will to flash, use the Up/Down (+/-) arrow buttons to alter the hour and press the Select button once to confirm.
What temperature should I set my thermostat UK?
The UK government used to recommend a temperature of 21 degrees for living rooms and 18 degrees for bedrooms, but now they just recommend 18 degrees for the whole home.
How do I reset my Danfoss programmer?
Step 1—Press and hold both the +1HR and MAN buttons located on the left-hand side of the controller. Step 2—While holding down the two buttons, press and hold the small RESET button for approximately 3 seconds. Step 3—Let go of only the reset button. The display will now show the current time.
How do I reset my Danfoss 715 thermostat?
Open the flap on the front of the clock. Press the RESET button using a non-metallic object (e.g. pencil/matchstick) until you hear a click and the 2 red lights on the front of the unit flash once. This will stop and restart the electronics, without losing the factory set time and date settings.
Can I have independent control of central heating and hot water?
The twin circuit Diadem and Tiara will also allow you to have independent control of Hot water and Central heating. INSTALLATION AND CONNECTION SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON AND IN ACCORDANCE WITH THE CURRENT EDITION OF THE IEE WIRING REGULATIONS.
Can I programme independent time settings for the hot water and heating?
On a FULLY PUMPED or CONTROLLED systems it is possible to programme independent time settings for Hot water and Heating. On GRAVITY or PARTIALLY CONTROLLED systems the Hot water and Heating follow a common time setting.
How do I install a programmer to the hcl9 backplate?
Now fit the programmer to the HCL9 backplate, line the lugs on the program- mer with the flanges on the HCL9 backplate. swing the top of the programmer into position ensuring that the connection blades on the back of the unit locate into the terminal slots in the backplate.