Can you offset a tub drain?

Can you offset a tub drain?

If you have enough clearance, you may be able to install an offset drain, where the drainpipe sits 2 inches to the side of the drain itself. Another option is to use 2-by-6 lumber instead of 2-by-4s to stud the wall beside the tub, thus bumping its drain away from the joist a useful 2 inches.

Are bathtub drains universal?

Bathtub drains are 1 1/2 inches wide and fit all standard bathtubs ranging from 14 to 26 inches deep. They are this size because they must fit the opening of the P-trap — also 1 1/2 inches wide — which is a special pipe that has a sharp bend in it.

What size is a claw foot tub drain?

Waste tube (shoe) is 18″ inches. Overflow tube is 18″ long. Bottom tube is 5″ inches. All tubes are designed to be cut to size to fit your specific installation.

Are tub drains interchangeable?

Although shower and tub drains serve the same function — to dispose of wastewater into your pipe drainage system — each one performs the task differently, and there are drain differences. Standalone shower tub drains and a tub or bathtub and shower combination drain cannot be used interchangeably.

How do you’re route a bathtub drain?

How to Move a Bathtub Drain Steps

  1. Mark the drain pipe coming down from the bathtub 1/2 inch above where it connects to the P-trap.
  2. Cut straight across the drain pipe with a hacksaw.
  3. Trim burrs off of plastic pipe with knife.
  4. Determine where the new bathtub drain will exit the bathroom floor.

Can I use PVC for tub drain?

Tub drain assemblies can be joined with slip fittings (brass, ABS, or PVC), or with solvent-glued fittings (ABS or PVC only). When using ABS or PVC that will be joined with solvent-glued fittings, make sure to stick with the same type of plastic found in the rest of the drain system.

Is brass or PVC better for bathtub drain?

PVC drains are generally more flexible, though brass, among the metals used for drains, is the most malleable. PVC is lightweight and easier to work with, whereas brass often requires more specialized labor.

What size hole is the overflow on a tub?

The Drain Hole The standard tub drain plug size is 1 ½” diameter. The drain size may be subject to local plumbing codes. The tub drain connects to the p-trap, or drain elbow, and should be large enough and unobstructed to allow the water to flow freely when opened.

Where does a claw foot tub drain?

Source and drain lines come through the floor. In a typical clawfoot tub installation, both the water source pipes and the drain pipe enter the bathroom through the floor.

Are all tub drains the same size?

Thanks to the standardization, any bathtub drain can fit any standard bathtub between 14 and 26 inches in depth. The size of the drain is standardized because it needs to fit to the P-trap, which is the next component of the drain.